UTR-70 Turbo Air Lapper
UTR-70 Turbo Air Lapper
UTR-70 Turbo Air Lapper
UTR-70 Turbo Air Lapper
  • UTR-70 turbo air lapper is driven by a turbine air motor.
  • BESDIA's air lapper features lots of advantages like low noise, low vibration, and durable tool life.
  • UTR-70 air lapper suits for general purpose polishing and finishing process of mold and die.
Stroke Air Pressure Weight Dimension
0.7 mm 90psi (6.2kg/cm2 ) 220g Ø28 x 200L (mm)
General Assembly
To upgrade performance and service life of air lappers

In order to maintain the best state of pneumatic tools and extend their life, the need arises to connect three points in combination so as to achieve the purpose of filtering water vapor, controlling the intake air pressure and lubrication.

  • Before using pneumatic tools, be sure to confirm if there is enough oil in the oiler of the threepoint combination.
  • Set the intake air pressure of three point combination to be 90 psi (6.2 kg / cm2) as the mostsuitable condition of use.
  • Before using, please check if the water filter bottle of three point combination is full. If full,please discharge the water first.
  • Adjust the oil intake quantity of three point combination. We recommend about 2 CC everyminute (if used often).
  • During the holidays or when the pneumatic tools are not used for a long time, when you first turn them on, please raise the oil intake quantity of the three point combination to reach 4 CC per minute. In addition, when switching on pneumatic tools, it is better to keep them idle at lowspeed for 20-30 seconds, so that oil lubricates each part, and then adjust to normal speed.
  • Lubricant oil choice: Do not use thick lubricant oil. It is recommended to use circulation oil R32.